Use and Care Manual

- 8 -
Installation
Model# UVF55
Before Installation
o The unit comes with two ports. Both are 1-inch MNPT and can be used as an inlet or outlet. Please choose the correct
fittings to fit your plumbing. For easy maintenance, it is recommended that you install an inlet valve and an outlet
valve before and after the unit. Please make sure that it can be easily disassembled from the water line for future
maintenance.
o The unit should be installed after a sediment filter, as sediments in the water can block UV light and become a shelter
for germs. Thus, water coming into the UV sanitizer must be clear (free of particles larger than 20 microns). It is
recommended that you install the UV sanitizer after the filters as the last stage.
o If water flow speed exceeds rated flow, please install a flow-limiting or pressure-limiting device. If the water pressure
is over 43 psi, please install a pressure regulator in the inlet/outlet in order to protect the quartz sleeve.
o Please install the sterilizer at a position by the retaining clip, retaining nuts or other mounting device in order to
prevent it from dropping due to the vibration caused by water and causing damages to the internal fragile parts.
o The ultraviolet water sterilizer is not a water filter. It is unable to eliminate bad tastes or smells, biological materials,
chemicals, silt, heavy metal and other kinds of impurities, and it does it does not reduce sediments which affects the
efficiency of the UV lamp. Therefore, it is necessary to install a pre-filter to ensure that the sterilizer can achieve
optimal performance.
Installation Steps
Step 1 - Before mounting the two black plastic clips onto the wall, make sure there is enough room for both the stainless-steel
housing and access for future servicing. It can be installed horizontally or vertically. (If you choose vertical mounting, make sure
that water inlet is mounted at a lower level while the outlet is at a higher level to slow down water flow and increase exposure
to the UV light.