Instructions / Assembly

ManualsBrandsISPRING ManualsKitchen2-Stage Whole House Water Filtration System with 4.5 in. x 10 in. Sediment and Carbon Block Filters

iSpring Whole House Water Filter System

WGB21B USER MANUAL

Version 1/2017

Introduction

Congratulations on the purchase of your WGB21B iSpring Whole House Water Filter system.

Featuring a two-stage filtration process, it was designed with your comfort and convenience in

mind. The WGB21B treats sediment, chlorine, VOCs, turbidity, sulfur smell, pesticides,

herbicides, and various other contaminants. The main purpose of the WGB21B is to deliver

clean, clear water to every faucet and bath in your home without drastically affecting water

pressure. The cartridges must be replaced on a regular basis to maintain efficiency and high

water quality. The filter cartridges work together and must be replaced every

3-6 months

depending on water quality and usage. Any significant change in performance of the system

should be investigated promptly to avoid deterioration to water quality.

CAUTION: Improperly installed systems can result in water damage due to leaks or flooding.

Proper installation of this system requires familiarity with standard sink plumbing and proper use

of common hand and power tools. If you are not familiar with standard sink plumbing and proper

use of common hand and power tools, consult a licensed professional such as a contractor or

plumber.

NOTE: This system may need be installed by a licensed professional, such as a contractor or

plumber.

Summary of content (5 pages)

PAGE 1
iSpring Whole House Water Filter System WGB21B USER MANUAL Version 1/2017 Introduction Congratulations on the purchase of your WGB21B iSpring Whole House Water Filter system. Featuring a two-stage filtration process, it was designed with your comfort and convenience in mind. The WGB21B treats sediment, chlorine, VOCs, turbidity, sulfur smell, pesticides, herbicides, and various other contaminants.
PAGE 2
System Operating Conditions Feed water pressure: 25 – 80 psi Feed water temperature: 40 – 100 degree F (4 – 37 degree C) Install the system in a sheltered environment; avoid exposure to hot and cold weather and direct sunlight. Move the system with caution and avoid dragging or dropping.
PAGE 3
Installation 1. Turn off the main line water shutoff valve to the house. 2. Open all plumbing fixtures in the house to drain the lines of water and pressure. 3. The filter should be placed on the main water supply line near where it enters the house at any point past the main shutoff valve for the whole house, but before pipes branch off into multiple directions. However you may choose to locate the filter after the line branches to the inside and outside plumbing depending on your filtration intent. 4.
PAGE 4
● After prolonged periods of nonuse (such as a vacation), it is recommended that the system be flushed thoroughly for at least 10 minutes before using the water. Filter Change Instructions 1. Turn off the water supply to the system. Depress the red pressure release button on the top of the filter housing to relieve system pressure. If your system was not equipped with a pressure relief valve, leave open a nearby faucet. This will make removing the filter housing easier. 2.
PAGE 5
Limited Warranty This Limited Warranty extends to the original purchaser of the system only. This warranty covers all Manufacturer-supplied items only that prove to be defective in material, workmanship or factory preparation. This warranty covers parts only; all labor is excluded from this warranty, including, but not limited to, services related to the removal, replacement, installation, adjustment, maintenance and/or repair of the unit or its components items.