WHOLE HOUSE USER MANUAL Version 04/2017 Introduction Congratulations on the purchase of your iSpring Whole House Water Filter system. When used to address its targeted contaminants, it will deliver clean, clear water to every faucet and bath in your home without drastically affecting water pressure. The filter cartridges work together and must be replaced every 3-6 months depending on source water quality and usage to maintain efficiency and output water quality.
System Operating Conditions Feed water pressure: 25 – 80 psi Feed water temperature: 40 – 100 degree F (4 – 37 degree C) Install the system in a sheltered environment; avoid exposure to excessively hot or cold weather and direct sunlight. Move the system with caution and avoid dragging or dropping.
Installation Your filter should be located in a dry, level area and protected from freezing temperatures and direct sunlight. 1. Turn off the water supply to your house before beginning the installation. 2. Turn off the electricity to your water heater before beginning the installation. 3. Open all plumbing fixtures in the house to release the lines of pressure. 4.
Notes ● Even though there is filtered water in the cold water lines, the hot water heater is still full of raw water. Through normal use, this water will be replaced with filtered water in about 2 or 3 days. ●This filter system should not be used with water that is microbiologically unsafe or of unknown quality without adequate disinfection before and/or after the system. ●The system should never be exposed to freezing temperatures. Damage from temperature is not covered under warranty.
Limited Warranty This Limited Warranty extends to the original purchaser of the system only. This warranty covers all Manufacturer-supplied items only that prove to be defective in material, workmanship or factory preparation. This warranty covers parts only; all labor is excluded from this warranty, including, but not limited to, services related to the removal, replacement, installation, adjustment, maintenance and/or repair of the unit or its components items.
Warranty Registration Visit www.123filter.com to complete warranty registration form online. To register your product for the warranty, visit our website123filter.com and go to the “Warranty Registration” tab.If you have any questions or concerns about your product, please do not hesitate to call or email us, or put it in the notes/comments upon your warranty registration.