Operator's Manual

8.1.2 Function Test

WARNING! Perform this test after any firearm conversion,

inspection, or part replacement.

WARNING! Make sure the TS12 Shotgun is cleared,

unloaded, and there is no ammunition in the chamber

(EMPTY) before performing the safety function test. The

muzzle should be pointed in a safe direction at all times.

WARNING! If the shotgun fails any of the steps of the

test, do not load or use the shotgun. Contact IWI US,

Inc. to return the shotgun for inspection and repair.

1. Visually inspect the weapon and verify that it is unloaded (see Unloading

and Safety Check Section on p.25).

2. Visually inspect the weapon and verify that it has been assembled

properly.

3. Pull the charging handle to the rear and release it. Verify proper and free

movement of the bolt assembly. If the bolt is locked at rearmost position

due to carrier stop function, press bolt release button.

4. Place the Safety Lever in the SAFE position (Red line hidden). Pull the

trigger. This should NOT release the hammer.

5. Set the Safety to FIRE position (Red line visible) and press the trigger

until the hammer falls and its release is heard.

6. Hold the trigger to the rear. Pull the Charging Handle to the rear and

release; continue holding the trigger to the rear. The bolt will stay to the

rear.

7. Drop the bolt using the bolt release button, then slowly release the

trigger with a slow and smooth motion until the trigger is fully forward.

An audible click should be heard. The hammer should not fall and is

reset.

8. Charge the shotgun and check the ability to set the safety lever to SAFE

position.

9. Verify the ability to charge the shotgun when the safety lever is set to

SAFE. The function test is complete.