Operator's Manual

40
9.4 Assembling the Receiver
Tools Required: none
To assemble the Receiver:
1. Install the recoil spring guide to its slot on bolt. The button
detent should face the rear. It can only be installed from one
direction (1).
2. Slide the bolt assembly through the bolt rail and seat it into the
chamber in the most forward locked position (2).
3. Slide the receiver from the rear until it fully seats onto the body.
The recoil spring guide and bolt rail must protrude through the
rear of the receiver (3).
4. Install the stock by pushing the stock down onto the body from
the rear and sliding it forward into position. The sling swivel cut
out must align with the cut out on the receiver. The recoil
spring guide and bolt rail must protrude through the rear of the
receiver (4).
5. Install the sling swivel sleeve by pressing the part into its slot on
stock from either direction. It must be centered in the stock (5).
6. Slide the recoil pad from the rear, aligning the rail and press
downwards until the recoil pad button snaps into place. You
may need to apply forward pressure against the stock while
sliding the buttpad onto the stock (6).
Figure 9-12 – TS12 Shotgun – Assembling the Receiver