Operator's Manual

General Description

11.3 Cleaning the Bolt Assembly

To clean the Bolt Assembly:

1. Wipe of the outside of the bolt assembly and clean under the

extractor using a cleaning toothbrush.

2. Remove the 2 bolt pins by driving them out with a punch in either

direction. Clean the bolt and inside the bolt carrier with patches and

a toothbrush.

3. After cleaning the bolt assembly, dry the parts off and apply a thin

coat between bolt body and bolt head.

4. To clean the firing pin channel, a small amount of degreaser may be

sprayed from the rear of the bolt toward the firing pin hole.

5. Wipe off the bolt face. This area should remain clean and dry.

WARNING! Always keep bolt rail cleaned and lightly

oiled!

WARNING! Cleaning agents, paint thinners, gun oils

and other chemicals may harm TS12 Shotgun’s

polymer parts.

WARNING! The Carrier Group Mechanism

disassembly can be performed ONLY by a certified

armorer!