User's Manual

ManualsBrandsiStarUSA ManualsMarine Sanitation SystemiStarUSA GAGE104U40 Series

GAGE104U40 Series

4 Bay 3.5” SAS/ SATA Trayless Enclosure

1U Desktop Type

User Manual

T:1.626.303.8885 F:1.626.301.0588 E:sales@istarusa.com W:www.istarusa.com

Summary of content (6 pages)

PAGE 1
GAGE104U40 Series 4 Bay 3.5” SAS/ SATA Trayless Enclosure 1U Desktop Type User Manual T:1.626.303.8885 F:1.626.301.0588 E:sales@istarusa.com W:www.istarusa.
PAGE 2
Package Contents 1. 2. 3. 4. 5. 6. 7. 8. 4-bay Enclosure x1 Power Cord x1 USB 3.0 Cable x1 eSATA Cable x1 1394a Cable x1 1394b Cable x1 User Manual x1 Rubber Feet x4 *miniSAS unit includes 1, 2, 7, 8 *eSATA unit includes 1, 2, 4(four cables), 7, 8 *USB/eSATA/FireWire includes 1 to 8 Hardware Guide 1. Door 2. HDD LED 3. Power Socket 4. Voltage Switch 5. eSATA 6. USB 3.0 7. FireWire400 8. FireWire800 9. RAID Switch 10. Power Button 11. Set Button (GAGE104U40SL-SAUF only) 12. HDD Release Latches 13.
PAGE 3
Operation -Hard disk installation 1.Open the door 2. Insert hard drives to the bottom 3. Close the door -Pull out the HDD Pull the HDD release latch, the HDD will be pushed out, and pull out the HDD carefully.
PAGE 4
-Connect to a Computer Connect data cable and power cord before turn on the unit. * for GAGE104U40SL-SAUF unit, do not use more than one connection at the same time, either USB, eSATA, or FireWire.
PAGE 5
RAID Mode (GAGE104U40SL-SAUF only) The unit provides 2 methods to change the RAID mode: 1. Switch the 3 dips in the back of the machine. 2. Use the application (for Windows and Mac only) to manage the RAID mode. (utility available on website www.istarusa.com) *must set to CLEAR mode first before changing to other RAID modes CLEAR Mode (down-down–down) CLEAR mode is the default mode. If you want to change from CLEAR mode to other RAID modes, please follow the procedure below.
PAGE 6
Rebuild Mode (GAGE104U40SL-SAUF only) The HDD access LED will be off and system will keep beeping when there is a HDD failure. Press the SET button to stop the beep. Rebuild Operation After turn off the power and change the failed HDD, system will start the rebuilding operation when the power is on again. *The new hard drive capacity should be larger or equal to the damaged one. *The Rebuild Operation will continue even the unit is not connected to a computer. *Do not change RAID mode during rebuilding.