Workshop Manual

6E–92
6VE1 3.5L ENGINE DRIVEABILITY AND EMISSIONS
No Reduced Power Lamp (RPL) (Cont'd)
Step NoYesValue(s)Action
25 1. Ignition “OFF”.
2. Reconnect all connectors.
3. Install the Tech 2.
4. Ignition “ON”.
5. Using the Tech 2 output controls function, select
RPL dash lamp control and command the RPL
“ON”. (Refer to the Miscellaneous test)
Did the RPL turn “ON”?
— Verify repair Go to Step 26
26 1. Ignition “OFF”.
2. Disconnect the PCM.
3. Check the circuit (DLC line) between PCM and
DLC.
Was a problem found?
— Go to Step 27 Go to Step 24
27 Locate and repair the circuit the between PCM and
DLC.
Is the action complete?
— Go to Step 25 —