Workshop Manual

6E–550
6VE1 3.5L ENGINE DRIVEABILITY AND EMISSIONS
Accelerator Pedal Replacement
Removal Procedure
1.Disconnect the negative battery cable.
2.Disconnect the electrical harness from the
accelerator position sensor.
101RY00006
Legend
(1) Accelerator Position Sensor
(2) Accelerator Pedal Assembly
3.Remove the two screws from the accelerator pedal
assembly.
101RY00007
4.Remove the accelerator pedal assembly from the
bulkhead.
Installation Procedure
1.Install the accelerator pedal assembly on the
bulkhead.
2.Install the two screws to the accelerator pedal
assembly.
Tighten
B Tighten the screws to 22 N·m (16 lb ft.).
101RY00007
3.Connect the electrical harness to the accelerator
position sensor.
101RY00006
Legend
(1) Accelerator Position Sensor
(2) Accelerator Pedal Assembly
4.Install the negative battery cable.