Workshop Manual

6E–584
6VE1 3.5L ENGINE DRIVEABILITY AND EMISSIONS
A continuous purge condition with no purge commanded
by the PCM will set a DTC P1441.
Poor idle, stalling and poor driveability can be caused by:
B A malfunctioning purge solenoid.
B A damaged canister.
B Hoses that are split, cracked, or not connected
properly.
Enhanced Evaporative Emission Control
System
The basic purpose of the Enhanced Evaporative
Emissions control system is the same as other EVAP
systems. A charcoal-filled canister captures and stores
gasoline fumes. When the PCM determines that the time
is right, it opens a purge valve which allows engine
vacuum to draw the fumes into the intake manifold.
The difference between this and other systems is that the
PCM monitors the vacuum and/or pressure in the system
to determine if there is any leakage. If the PCM
determines that the EVAP system is leaking or not
functioning properly, it sets a Diagnostic Trouble Code
(DTC) in the PCM memory.
The enhanced EVAP system is required to detect
evaporative fuel system leaks as small as 0.020 in. (1.0
mm) between the fuel filler cap and purge solenoid. The
system can test the evaporative system integrity by
applying a vacuum signal (ported or manifold) to the fuel
tank to create a small vacuum. The PCM then monitors
the ability of the system to maintain the vacuum. If the
vacuum remains for a specified period of time, there are
no evaporative leaks and a PASS report is sent to the
diagnostic executive. If there is a leak, the system either
will not achieve a vacuum, or a vacuum cannot be
maintained. Usually, a failure can only be detected after a
cold start with a trip of sufficient length and driving
conditions to run the needed tests. The enhanced EVAP
system diagnostic will conduct up to eight specific
sub-tests to detect fault conditions. If the diagnostic fails
a sub-test, the PCM will store a Diagnostic Trouble Code
(DTC) to indicate the type of detected.