Workshop Manual

7A–29
AUTOMATIC TRANSMISSION (4L30–E)
10.Remove selector lever subassembly.
256R200005
Installation
1.Install selector lever subassembly.
2.Connect harness connector.
3.Connect shift lock cable.
B Refer to
Shift Lock Cable in this section.
4.Connect select cable.
B Refer to
Select Cable in this section.
5.Install selector lever knob and cover assembly.
6.Install front console.
7.Install rear console.
8.Install center cluster assembly, cluster upper cover
and knee pads.
9.Connect negative (–) battery cable.
10.After installation, make sure that the selector lever
operates normally, and that each selector position is
properly indicated. (The red mark shows through the
window.)
Select Cable
Removal
1.Set selector lever in “P” position.
2.Remove knee pads, cluster upper cover, center
cluster assembly, rear console, front console,
selector lever knob and cover assembly.
B Refer to
Selector Lever in this section.
3.Disconnect inner cable by pulling projection on pin.
256R200006