Workshop Manual

7A–52
AUTOMATIC TRANSMISSION (4L30–E)
Transmission Oil Temperature Sensor (Main Case)
Removal
1.Raise the vehicle and support it on jack stands.
2.Disconnect battery ground cable.
3.Drain fluid.
4.Remove sixteen 10 mm main case oil pan fixing
screws, main case oil pan, and gasket.
5.Disconnect wiring harness from shift solenoids, band
apply solenoid, and 7 way connector of main case.
Pull only on connectors, not on wiring harness.
6.Remove wiring harness assembly with transmission
oil temperature sensor.
244RY001
Installation
1.Install wiring harness assembly with transmission oil
temperature sensor to band apply solenoid, shift
solenoids, and 7 way connector of main case.
2.Install oil pan gasket, oil pan, and sixteen 10 mm
fixing screws. Tighten the screws to the specified
torque.
Torque: 11 N•m (96 lb in)
3.Fill transmission through the overfill screw hole of oil
pan, using ATF DEXRON–III.
Refer to Changing Transmission Fluid in this section.
4.Connect battery ground cable.