Workshop Manual

7A–60
AUTOMATIC TRANSMISSION (4L30–E)
NOTE: Use petroleum jelly to hold the washer and
bearing in place.
242RW002
16.Carefully align the second clutch plate inner tangs.
B Install thrust washer, tangs pointing downward, and
locating tang positioned in slot on second clutch
hub.
NOTE: Use petroleum jelly to hold thrust washer in place.
17.Install third clutch and intermediate shaft assembly
(13) into the second clutch drum (14).
18.Install second and third clutch assemblies into the
main case. Twist output shaft and clutch assemblies
to ensure proper fit.
247RS001
19.Install pressure plate (15) with lip side up, tang facing
valve body face.
20.Install reverse clutch plates. Start with a steel plate
(17) and alternate with a lined plate (16).
21.Install waved clutch plate (18) with center tang facing
valve body side.
247RS002