Workshop Manual

POWER–ASSISTED STEERING SYSTEM
2A–15
NOTE: Overall thickness of caster shim and camber
shim should be 10.8 mm (0.425 in) or less.
Tighten the fulcrum pin bolt to the specified torque.
Torque: 152 N·m (112 lb ft)
Position of shims
Camber angle
Caster angle
Front side Rear side
Camber
angle
Caster
angle
When added When removed Decreases Decreases
Caster shim
When removed When added Increases Increases
Caster
shim
— When removed Unchanged Decreases
— When added Unchanged Increases
Camber shim
When added Decreases Unchanged
Camber
shim
When removed Increases Unchanged
Toe-in Adjustment
1.To adjust the toe-in angle, loosen the lock nuts (2) on
the tie rod (1) and turn the tie rod. Turn both rods the
same amount, to keep the steering wheel centered .
Toe-in: 0 to +2 mm (0 to +0.08 in)
433RW003
2.Tighten the lock nut to the specified torque.
Torque: 98 N·m (72 lb ft)