Workshop Manual

2A–20
POWER–ASSISTED STEERING SYSTEM
7.
a. Align the setting marks made at removal.
Install the universal joint assembly to the transfer
gear assembly.
Temporary tighten the universal joint bolt.
b. Install the universal joint assembly to the power
steering unit assembly.
Temporary tighten the universal joint bolt.
c. Install the transfer gear assembly with the shim to
frame.
Torque: 54 N·m (40 lb ft)
d. Tighten the universal joint bolt to the specified
torque.
Torque: 31 N·m (23 lb ft)
8.Install the stone guard.
9.Bleed the system.
Refer to Bleeding the Power Steering System in this
section.
Power Steering Unit Disassembled View
440R100002
Legend
(1) Tie-rod End
(2) Lock Nut
(3) Clip
(4) Bellows
(5) Band
(6) Tie-rod Assembly
(7) Tab Washer
(8) Oil Line
(9) Valve Housing Assembly
(10) Mounting Rubber
(11) Dust Cover