Workshop Manual

POWER–ASSISTED STEERING SYSTEM
2A–23
Power Steering Pump
Power Steering Pump and Associated Parts
436RX001
Legend
(1) Pump Assembly
(2) Hose, Suction
(3) Hose, Flexible
(4) Bolt
Removal
1.Remove the drive belt.
2.Place a drain pan below the pump.
3.Disconnect the suction hose.
4.Disconnect the flexible hose.
5.Remove the power steering fixing bolt and remove
the pump assembly.
Installation
1.Install the pump assembly to the pump braket, tighten
the fixing bolt to the specified torque.
Torque: 46 N·m (34 lb ft)
2.Install the flexible hose.
Tighten the eye bolt to specified torque.
Torque: 54 N·m (40 lb ft)
3.Install the drive belt.
4.Connect the suction hose, then fill and bleed system.
Refer to Bleeding the Power Steering System in this
section.