Workshop Manual

2A–26
POWER–ASSISTED STEERING SYSTEM
3.Install the vanes to roter with curved face in contact
with the inner wall of cam.
442RS005
4.Install rotor and vanes to cam.
5.Install pin to front housing.
6.Install two new O-rings to front housing. Be sure to
discard used O-ring.
7.Install side plate.
CAUTION: When installing side plate, be careful not
to damage its inner surface. Damaged side plate may
cause poor pump performance, pump seizure or oil
leakage.
8.Install pump cartridge assembly to front housing.
9.Install snap ring to shaft end.
10.Install rear housing with a new O-ring. Be sure to
discard used O-ring. Then install bolt and tighten it to
specified torque.
Torque: 24 N·m (17 lb ft)
11.Install suction pipe with a new O-ring. Be sure to
discard used O-ring. Then install bolt and tighten it to
specified torque.
Torque: 10 N·m (87 lb in)
12.Install relief valve and spring.
13.Install connector with a new O-ring. Be sure to
discard used O-ring. Tighten the connector to
specified torque.
Torque: 59 N·m (43 lb ft)
14.Install pressure switch assembly and tighten it to
specified torque.
Torque: 18 N·m (13 lb ft)