Workshop Manual

8A–4
LIGHTING SYSTEM
Headlight Assembly
Removal
1.Disconnect the battery ground cable.
2.Remove the front combination light (2).
B Remove the screw.
B Disconnect the connector.
3.Remove the headlight assembly (1).
B Disconnect the connector.
B Remove four screws.
801R200022
Installation
To install, follow the removal steps in the reverse order.
noting the following point:
1.After installing the headlight, be sure to adjust the
headlight aim.
Headlight Adjustment
Preparation
Place the vehicle with 1 person in driver seat on a level
surface and check to see if the inflation pressure of the
tires is correct, the lenses are clean, the battery is
sufficiently charged, and adjust to place vehicle by using
the screen.
1.Set a vertical screen on a level surface.
2.Toward the screen (1) from the bulb center mark of
the headlight, extend parallel lines to the floor. Mark
point (A) and (B) on the screen at the intersection of
parallel line and the screen.
3.Draw vertical lines through point (A) and (B) on the
screen.
801R200019
4.Keep the vehicle (2) 3m (9.8 ft) apart from the screen
(1).
5.Draw a horizontal line through point (A) and (B) on the
screen (1).
801R200009