Workshop Manual

LIGHTING SYSTEM
8A–11
Rear Turn Signal Light Bulb
Removal
1.Disconnect the battery ground cable.
2.Remove the rear combination light assembly.
B Refer to Taillight Bulb in this section.
3.Remove the bulb (1).
B Remove the rear turn signal light socket by turning it
counterclockwise.
B Remove the bulb by turning it counterclockwise
while pushing it at the same time.
803R200006
Installation
To install, follow the removal steps in the reverse order.
Dome Light Bulb
Removal
1.Disconnect the battery ground cable.
2.Remove the lens (2).
3.Remove the bulb (1).
B Pull out the bulb.
825RW075
Installation
To install, follow the removal steps in the reverse order.