Workshop Manual

8B–6
WIPER/WASHER SYSTEM
Windshield Wiper Arm/Blade
Removal
1.Pry the cap(2) off with the tip of a screwdriver.
2.Remove the nut.
3.Remove the wiper arm/blade(1).
880RW003
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
880RW006
1.Before installing the wiper arm/blade to the shaft,
confirm that the motor stops at the autostop position.
2.Set the wiper arm/blade so that the tips of both blades
are positioned about 40 mm (1.57 in) from the upper
edge of the cowl cover as shown in the figure.
3.Tighten the nuts to the specified torque.
Torque: 23 N·m (17 lb ft)