Workshop Manual

8B–8
WIPER/WASHER SYSTEM
Rear Wiper/Washer System
General Description
The circuit consists of the starter switch, rear wiper &
washer switch, rear wiper motor, rear washer motor and
Alarm & relay control unit.
When the rear wiper & washer switch is turned on with the
starter switch on, the battery voltage is applied to the
wiper motor to activate the wiper.
The washer motor squirts glass cleaning fluid while the
washer switch is being pushed. The alarm & relay control
unit is used to control motion of the wiper.
Rear Wiper and Washer Switch
Removal
1.Disconnect the battery ground cable.
2.Remove the dash side trim panel(1).
3.Remove the lower cover assembly(2).
821RW254–1
4.Remove the rear wiper & washer switch (4).
B Disconnect the connector.
B Push the lock from the back side of the lower cover
assembly (3).
825R200028
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
1.Push the switch with your fingers until it locks
securely.