Workshop Manual

WIPER/WASHER SYSTEM
8B–9
Rear Wiper Motor
Removal
1.Disconnect the battery ground cable.
2.Remove the tailgate trim pad.
B Refer to Tailgate Trim Pad in Body Structure
section.
3.Remove the wiper arm/blade.
Refer to Rear Wiper Arm/Blade in this section.
4.Remove the rear wiper motor (1).
B Disconnect the connector.
B Remove the rear wiper motor fixing screws.
885R200002
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1.Before installing the wiper arm/blade (1) to the motor
shaft (6), confirm that the motor stops at the autostop
position.
2.Tighten the motor shaft nut (5) to the specified torque.
Torque: 10 N·m (87 lb in)
3.Tighten the wiper arm nut (3) to the specified torque.
Torque: 9 N·m (78 lb in)
885R200001
4.Install the wiper arm/blade so that the wiper arm
contact as shown in the figure.
885R200005