Workshop Manual

8C–2
ENTERTAINMENT
Cigarette Lighter
General Description
When the cigarette lighter is pushed in with the starter
switch at either “ACC” or “ON” position, a circuit is formed
in the cigarette lighter case to heat the lighter coil.
The cigarette lighter springs back to its original position
after the lighter coil is heated.
Removal
1.Disconnect the battery ground cable.
2.Remove the center cluster assembly (1).
B Refer to
Instrument Panel Assembly in Body
Structure section.
3.Remove the cigarette lighter assembly (2).
B Disconnect the connectors.
B Remove the socket (3) and nut (4).
826R200012
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
1.When installing the bezel, align the projected portion
of the socket with the notch of the bezel.