Workshop Manual

2A–38
POWER–ASSISTED STEERING SYSTEM
CAUTION: Never apply force to the steering wheel
shaft using a hammer or other impact tools in an
attempt to remove the steering wheel. The steering
shaft is designed as an energy absorbing unit.
430RX005
9.Remove steering column cover.
10.Disconnect the wiring harness connectors located
under the steering column then remove combination
switch and SRS coil assembly.
825RW288
Installation
1.Install combination switch and SRS coil assembly.
After installation of combination switch assembly,
connect the combination switch wiring harness
connector and the SRS 2-way connector located
under the steering column. Then turn the SRS coil
counter clockwise to full, return about 3 turns and
align the neutral mark.
CAUTION: Turn the SRS coil counter clockwise
until some resistance is felt, or damage may occur to
the SRS coil.
825RW016