Workshop Manual

8F–16
BODY STRUCTURE
Removal
1.Disconnect the battery ground cable.
2.Remove the front bumper fascia assembly.
B Refer to
Front Bumper in this section.
3.Remove the front turn signal light assembly.
B Remove the fixing screw and disconnect the
connector.
610R200008
4.Remove the rocker cover assembly.
B Refer to Rocker Cover Assembly in Exterior/Interior
Trim section.
5.Remove the inner liner.
647RY00003
6.Remove the antenna assembly.
B Refer to
Rod Type Antenna in Entertainment
section.
7.Remove the front fender panel (1).
B Remove the eight fixing bolts.
8.Remove the engine compartment upper extension
(2).
614R200002
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1.Tighten the front fender panel fixing bolts to the
specified torque.
Torque : 7 N·m (61 lb in)
2.Check the fender and front door (1).
Clearance: 5.0 mm (0.196 in)
Height (step): Flush
610R200009