Workshop Manual

8F–34
BODY STRUCTURE
B Disconnect the instrument harness connectors (six
connectors on the driver’s side, three connectors
on the passenger side and two connectors on the
center side).
B Disconnect radio antenna cable plug and the
ground cable fixing bolts from dash side panel.
B Remove the two fixing bolts of passenger air bag
assembly and disconnect the connector.
B Remove the two fixing screws from fuse box.
B After pry the three hole cover from the surface of
instrument panel, remove the three nuts.
B Remove the six bolts and one screw.
740R200022
15.Remove the passenger air bag (1).
B Remove the four fixing nuts.
CAUTION: For precautions on installation or
removal of SRS – air bag system, refer to
Supplemental Restraint System in Restraint section.
827RY00004
16.Remove the vent duct assembly.
B Remove the five fixing screws.
17.Remove the passenger lower bracket.
B Remove the three screws.
18.Remove the glove box side reinforcement.
19.Remove the instrument upper reinforcement.
B Remove the nine screws.
20.Remove the instrument panel center reinforcement.
B Remove the six screws.
21.Remove the instrument panel harness assembly (1).
B Remove the clips.
740R200023
22.Remove the instrument panel stays.
B Remove the two fixing nuts and two fixing bolts for
each bracket.
23.Remove the cross beam.
B Remove the five fixing nuts, two fixing bolts (upper)
and six fixing bolts (lower).
840RW005
Installation
To install, follow the removal steps in the reverse order.