Workshop Manual

8F–56
BODY STRUCTURE
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
641R200003
Legend
(1) Primer Coating Area (Glass side)
(2) Adhesive
(3) Primer Coating Area (Body panel side)
(4) Rear Quarter Glass
(5) Moulding
1.Clean the bonding surfaces of both the window glass
and body panel with a soft rag and white gasoline.
2.Apply the primer to the window glass and body panel.
B Apply the primer (Sun star # 435-40 or equivalent)
to the window glass side bonding surface as shown
in the figure.
B Apply the primer (Sun star # 435-95 or equivalent)
to the body side bonding surface.
3.Apply sealing adhesive to the window glass.
B Make sure that the primer has dried completely.
B Apply sealing adhesive (SunStar 555 or the
equivalent) to the circumference of the window
glass. There should be a 20 mm (0.79 in) overlap at
the lower front corner of the glass.
4.Attach the fastener tape and spacers to the points
shown in the illustration.
5.Attach the glass clips to the panel. Press the glass
into the panel until it adheres to the panel.
NOTE: Immediately wipe away any excess sealing
adhesive oozing from the panel and glass.
6.Allow the assembly to dry for 24 hours (20∼30°C).
7.Check to make sure that there is no water leakage
from the rear quarter glass.