Workshop Manual

POWER–ASSISTED STEERING SYSTEM
2A–43
7.When installing the steering column cover, be sure to
wire (through each harness) as illustrated so that the
harnesses starter switch, combination switch and
SRS coil may not catch wiring.
825RW017
Legend
(1) Steering Column Cover
(2) Starter Switch Harness
(3) Combination Switch Harness
(4) Inflator Module Harness
8.Install steering wheel by aligning the setting marks
made during removal.
CAUTION: Never apply force to the steering wheel
shaft using a hammer or other impact tools in an
attempt to remove the steering wheel. The steering
shaft is designed as an energy absorbing unit.
9.Tighten the steering wheel fixing nut to the specified
torque.
Torque: 34 N·m (25 lb ft)
10.Support inflator module and carefully connect the
SRS connector and horn lead, then install inflator
module.
NOTE: Pass the lead wire through the tabs on the plastic
cover (wire protector) of inflator to prevent lead wire from
being pinched.
11.Tighten fixing bolts to specified torque.
Torque: 9 N·m (78 lb in)
12.Install driver knee bolster (reinforcement).
13.Install instrument panel lower cover, then install the
engine hood opening lever.
14.Connect the yellow 2-way SRS connector located
under the steering column.
15.Connect the battery ground cable.
System Inspection
Turn the ignition switch to the “ON” position and observe
the warning lamp. The lamp should flash 7 times. If the
lamp does not operate correctly, refer to Restraints
section.