Workshop Manual

SUN ROOF/CONVERTIBLE TOP
8I–3
Installation
1.Be sure to install the sunroof weatherstrip so that the
joint of the weatherstrip is on the rear side of the
vehicle.
2.Temporary install the glass to the sunroof frame.
3.Open and shut the sunroof four to five times to
position correctly the sunroof weatherstrip and the
glass in the longitudinal and latitudinal setting
positions.
4.Adjust the setting position to flush the surface
between the roof panel and weatherstrip of sunroof
glass.
5.Tighten the sunroof glass fixing screws to the
specified torque.
Torque: 4 N·m (35 lb in)
6.Inspect the sunroof alignment after installing the
sunroof glass. Use the fixing screws to adjust the
sunroof if not aligned.
Sunroof Deflector
Removal
1.Open the sunroof.
B Let a 5 mm (0.20 in) drill go through two blind rivets
(2) to disengage riveted portions.
2.Remove the sunroof deflector (1).
665R200001
Installation
To install, follow the removal steps in the reverse order.