Workshop Manual

EXTERIOR/INTERIOR TRIM
8J–13
4.Remove the luggage room light.
B Remove the luggage room light lens (1) and the
fixing screw.
B Disconnect the luggage room light connector.
825R200030
5.Remove the overhead console/sunroof switch (With
sunroof).
B Refer to
Overhead Console in this section.
6.Remove the overhead console (without sunroof).
7.Remove the sunvisors.
B Remove the fixing screws and pull out the sunvisor
holder (1) to remove it.
B Disconnect the vanity mirror illumination connector.
743R200003
8.Remove the sunroof finisher (With sunroof).
9.Remove the headlining.
B Remove the four headlining fixing clips.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1.Install the headlining so that the fixing clips will not
come off.
2.To install the sunroof finisher (1), first fit it in at one
place with the headlining (3) close to the sunroof
frame (2), then install the entire finisher tightly by
hitting it with a plastic hammer, not allowing it to move
up.
665RW003