Workshop Manual

EXTERIOR/INTERIOR TRIM
8J–21
Power Window System
General Description
The power window system consists of power window
switches and power window motors on driver and
passenger sides and power window relay. With the starter
switch in “ON” position, the battery voltage is supplied
through power window relay to the power window
switches on driver and passenger sides. Selection of up
or down switch changes the motor rotating direction to
open or close the window.
When the power window “LOCK” switch on the driver side
is pressed, the power source for the other switches are
disconnected causing the power window operation to
seize.
Power Window Switch Driver Seat
Side
Removal
1.Disconnect the battery ground cable.
2.Remove the switch (1).
B Pull out the switch by pushing the spring with the tip
of a screwdriver.
B Disconnect the connector.
635R200002
Installation
To install, follow the removal steps in the reverse order.
Front Passenger Seat Side
Removal
1.Disconnect the battery ground cable.
2.Remove the switch (1).
B Pull out the switch by pushing the spring (2) with the
tip of a screwdriver.
B Disconnect the connector.
825R200025
Installation
To install, follow the removal steps in the reverse order.
Rear-Left and Right Sides
Removal
1.Disconnect the battery ground cable.
2.Remove the rear power window switch (1).
B Pull out the switch by pushing the spring with the tip
of a screwdriver.
B Disconnect the connector.
655R200004
Installation
To install, follow the removal steps in the reverse order.