Workshop Manual

SEAT BELT SYSTEM
9A–11
2.Remove the headrests.
3.Pull the release knobs and fall down the seat back
assembly forward.
4.Remove the seat lock covers.
B Remove the three fixing screws from each seat lock
cover.
5.Remove the front luggage floor carpets.
B Pull the nine carpet fixing clips from the backside of
the seat back assembly.
6.Remove the four lower anchorage strikers.
B Remove the two fixing bolts of each lower
anchorage striker.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1.Install the lower anchorage strikers with matching the
inside of the tab and the trim edge of the body floor
panel.
755R100008
2.Tighten the lower anchorage striker fixing bolts to the
specified torque.
Torque: 25 N·m (18 lb ft)