Workshop Manual

SUPPLEMENTAL RESTRAINT SYSTEM
9J–33
7.Install the steering wheel and align the setting marks
(4).
8.Tighten the steering wheel fixing nut (5) to the
specified torque.
Torque: 34 N·m (25 lb ft)
9.Connect horn lead (1).
10.Connect air bag to wiring harness connector (2).
NOTE: Pass the lead wire through the tabs on the plastic
cover (wire protector) of air bag to prevent lead wire from
being pinched.
11. Install Air Bag (6) into steering wheel and tighten bolts
(8) to specified sequence as figure.
Torque: 8.8 N·m (78 lb in)
CAUTION: Never use the air bag assembly from
another vehicle and difference model year air bag
assembly.
The air bag assembly has identification colors on the
bar code label as follows.
Light blue color for driver air bag assembly.
Light blue color for passenger air bag assembly.
Use only the air bag assembly for “UP”.
825RX008
12.Enable the SRS. (Refer to “Enabling The SRS” in this
section.)