Workshop Manual

RESTRAINT CONTROL SYSTEM
9J1–12
Chart C “AIR BAG” Warning Lamp Does Not Comes “ON” Steady (Cont’d)
Step NoYesAction
9 1. Disconnect SRS coil and passenger air bag assemblies.
Yellow 2–pin connectors located at base of steering column
and behind the glove box assembly.
2. Disconnect SDM.
3. Replace “MA01” meter fuse.
4. Ignition switch “ON” wait to 10 seconds.
5. Ignition switch “OFF”.
6. Remove and inspection “MA01” meter fuse.
Is fuse good?
Install “MA01”
meter fuse.
Go to Chart A .
Replace SRS
harness.
Replace“MA01”
meter fuse.
Go to Step 10
10 Reconnect all SRS components, ensure all components are
properly mounted.
Was this step finished?
Repeat the “SRS
Diagnostic
System Check.”
Go to Step 10