Workshop Manual

3C–6
FRONT SUSPENSION
Stabilizer Bar
Stabilizer Bar and Associated Parts
410R200001
Legend
(1) Rubber Bushing
(2) Bracket and Bolt
(3) Link
(4) Nut
(5) Stabilizer Bar
(6) Washer
Removal
1.Raise the vehicle and support the frame with suitable
safety stands.
2.Remove the stone guard.
3.Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
4.Remove nut.
CAUTION: Be careful not to break the ball joint boot.
5.Remove link.
6.Remove bracket.
7.Remove stabilizer bar.
8.Remove rubber bushing.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts :
B Stabilizer bar
B Rubber bushing
B Link ball joint
Installation
1.Install rubber bushing.
2.Install stabilizer bar.
3.Install bracket, then tighten it to the specified torque.
Torque: 25 N·m (18 lb ft)
4.Install link and Washer.
5.Install nut, then tighten it to the specified torque.
Torque: 50 N·m (37 lb ft)