Workshop Manual

3C–8
FRONT SUSPENSION
3.Apply the setting marks(2) to the height control arm
and torsion bar, then remove height control arm.
410RS005
4.Apply the setting marks(3) to the torsion bar and
lower control arm, then remove torsion bar.
410RS006
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts:
B Torsion bar
B Height control arm
B Adjust bolt
B Rubber seat
Installation
1.Apply grease to the serrated portions, then install
torsion bar. Make sure the bars are on their correct
respective sides and align the setting marks(3).
410RS007
410RS006