Workshop Manual

3C–10
FRONT SUSPENSION
Knuckle
Knuckle and Associated Parts
410RW006
Legend
(1) Torsion Bar
(2) Lower Ball Joint, Nut and Cotter Pin
(3) Back Plate
(4) Knuckle Assembly
(5) Knuckle
(6) Needle Bearing (4WD MODEL)
(7) Thrust Washer (4WD MODEL)
(8) Oil Seal (4WD MODEL)
(9) Upper Ball Joint, Nut and Cotter Pin
(10) Wheel Speed Sensor
Removal
1.Raise the vehicle and support the frame with suitable
safety stands.
2.Remove wheel and tire assembly. Refer to Wheel in
this section.
3.Remove the brake caliper. Refer to Disc Brakes in
Brake section.
4.Remove the hub assembly. Refer to Front Hub and
Disk in this section.
5.Remove tie–rod end from the knuckle. Refer to Power
Steering Unit in Steering section.
6.Remove the speed sensor from the knuckle.
7.Loosen torsion bar by height control arm adjust bolt,
then remove torsion bar. Refer to
Torsion Bar in this
section.
8.Remove wheel speed sensor.