Workshop Manual

REAR SUSPENSION
3D–13
B Install the rubber bushing (Frame side) by using
Installer J–39215.
NOTE: When mounting rubber bushings, do not use
grease on bushings or any other nearby parts.
901RW061
3.Rubber bushing (Axle side)
B Remove the rubber bushing (Axle side) by using
remover J–39792.
901RW062
B Install the rubber bushing (Axle side) by using
installer J–39792.
901RW063
Installation
1.Install lateral rod and make sure that the lateral rod is
in its correct position.
NOTE: When mounting lateral rod, be sure not to use
grease on bushings or any other nearby part.
460RW008
Legend
(1) Frame Side
(2) Axle Side
2.Install bolt and nut (Frame side). Tighten the bolt and
nut lightly, then retighten them to the specified torque
after the vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3.Install nut and washer (Axle side). Tighten the nut
lightly, then retighten the nut to the specified torque
after the vehicle is at curb height.
Torque: 78 N·m (58 lb ft)