Workshop Manual

0B–11
MAINTENANCE AND LUBRICATION
Recommended Liquid Gasket
Type Brand Name Manufacturer Remarks
RTV*
Silicon Base
Three Bond 1207B
Three Bond 1207C
Three Bond 1215
Three Bond 1280
Three Bond 1281
Three Bond
Three Bond
Three Bond
Three Bond
Three Bond
For Engine Repairs
For Axle Case
Repairs T/M
Repairs T/M
Water Base Three Bond 1141E Three Bond For Engine Repairs
Solvent
Three Bond 1104
Belco Bond 4
Belco Bond 401
Belco Bond 402
Three Bond
Isuzu
Isuzu
Isuzu
For Engine Repairs
Anaerobic
LOCTITE 515
LOCTITE 518
LOCTITE 17430
Loctite
Loctite
Loctite
All
* RTV: Room Temperature Vulcanizer
NOTE:
1.It is very important that the liquid gaskets listed above
or their exact equivalent be used on the vehicle.
2.Be careful to use the specified amount of liquid
gasket.
Follow the manufacturer’s instructions at all times.
3.Be absolutely sure to remove all lubricants and
moisture from the connecting surfaces before
applying the liquid gasket.
The connecting surfaces must be perfectly dry.
4.Do not apply LOCTITE 17430, LOCTITE 515 and
LOCTITE 518 between two metal surfaces having a
clearance of greater than 0.25 mm (0.01 in). Poor
adhesion will result.
Recommended Thread Locking
Agents
LOCTITE Type LOCTITE Color
LOCTITE 242 Blue
LOCTITE 262 Red
LOCTITE 271 Red
Application Steps
1.Completely remove all lubricant and moisture from
the bolts and the female-threaded surfaces of the
parts to be joined.
The surfaces must be perfectly dry.
2.Apply LOCTITE to the bolts.
F00RW014
3.Tighten the bolts to the specified torque.
After tightening, be sure to keep the bolts free from
vibration and torque for at least an hour until
LOCTITE hardens.
NOTE: When the application procedures are specified in
this manual, follow them.