Workshop Manual

3F–26
INTELLIGENT SUSPENSION
DTC6 Stop Lamp Switch Open Circuit or Short (Cont’d)
Step NoYesValue(s)Action
9 Replace the brake switch.
Is the replacement complete?
— Go to Step 13 —
10 1. Turn the ignition “off”.
2. Reconnect the control unit connector C–44
Turn the ignition “on”.
Does the brake lamp come on when the brake pedal is
applied and does it come off when the brake pedal is
released?
—
Go to
Diagnostic
Aids
Go to Step 11
11 Check the control unit for faulty or intermittent
connections.
Was a problem found and corrected?
— Go to Step 13 Go to Step 12
12 Replace the control unit.
Is the replacement complete?
— Go to Step 13 —
13 1. After the repair is complete, clear the DTC.
2. Conduct a test drive.
3. Review the DTC.
Has the last test failed or is the current DTC displayed?
—
Begin diagnosis
again
Go to Step 1
Go to Repair
verified