Workshop Manual

4A1–7
DIFFERENTIAL (FRONT)
3.Tighten the mounting bolts and nuts to the specified
torque.
Torque: 168 N·m (124 lb ft)
412R200004
4.Install the right side knuckle with lower control arm to
the upper control arm.
Refer to
Knuckle in Suspension section.
CAUTION: Carefully insert the drive shaft into the
knuckle, to avoid damaging the oil seal.
5.Align the bolt hole of the lower control arm, then install
the bolts and nuts.
NOTE: Adjust the buffer clearance before tightening the
bolts and nuts of the lower control arm.
6.Install the hose of the shift on the fly.
7.Install the actuator connector of the shift on the fly.
8.Install the tie-rod end of the power steering unit to the
knuckle, tighten the nut to the specified torque.
Torque: 118 N·m (87 lb ft)
9.Install lower bolts and nuts of the shock absorber,
tighten it to the specified torque.
Torque: 93 N·m (69 lb ft)
10.Install lower nuts of the stabilizer link, tighten it to the
specified torque.
11.Install the suspension crossmember.
12.Install the torsion bar.
Refer to
Torsion Bar in Suspension section.
13.Install the front propeller shaft.
Refer to Front Propeller Shaft in this section.
14.Install the hub and disc assembly and adjust the
bearing preload.
Refer to Front Hub and Disc in this section.
15.Install the wheel speed sensor of the antilock brake
system.
16.Install the brake caliper. Tighten the bolt of the caliper
bracket to the specified torque.
Torque: 50 N·m (37 lb ft)
17.Install the stone guard.
18.Install the tire and wheel.
19.Lower the vehicle, adjust the trim height.
Refer to Trim Height Adjustment in Steering section.
20.Tighten the bolts and nuts of the lower control arm to
the specified torque.
Refer to
Lower Control Arm in Suspension section.