Workshop Manual

4A1–21
DIFFERENTIAL (FRONT)
4.Remove the cross pin, using a soft metal rod and a
hammer.
425RS043
5.Remove pinion gear.
6.Remove side gear.
7.Remove thrust washer.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts.
1.Ring gear, pinion gear
2.Bearing
3.Side gear, pinion gear, cross pin
4.Differential cage, carrier
5.Thrust washer
6.Oil seal
Ring gear replacement:
1.The ring gear should always be replaced with the
drive pinion as a set.
2.Discard used bolts and install new ones.
Torque: 108 N·m (80 lb ft)
3.Tighten the fixing bolts in a diagonal sequence as
illustrated.
415RS016
Reassembly
1.Install thrust washer.
2.Install side gear.
3.Install the pinion gear with thrust washer by engaging
it with the side gears while turning both pinion gears
simultaneously in the same direction.
425RS048