Workshop Manual

HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
1A–11
Heater Temperature Control Link Unit
Disassembled View
860R200003
Legend
(1) Case (Temperature control)
(2) Door Lever
(3) Clip
(4) Rod
(5) Clip
(6) Sub-lever
(7) Mix Actuator
(8) Heater Unit
Removal
1.Disconnect the battery ground cable.
2.Drain engine coolant.
3.Discharge and recover refrigerant (with air
conditioning).
B Refer to Refrigerant Recovery in this section.
4.Remove heater unit.
B Refer to
Heater Unit in this section.
5.Remove mix actuator.
6.Remove the case (Temperature control) from the
heater unit.
7.Remove rod.
8.Remove sub-lever.
9.Pull out the door lever while raising up the catch of the
door lever.
10.Remove clip.
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1.Apply grease to the sub-lever and to the abrasive
surface of the heater unit.
2.After installing the link unit, check to see if the link unit
operates correctly.