Workshop Manual

4B2–93
DRIVE LINE CONTROL SYSTEM (TOD)
Step NoYesAction
8 1. Connect the connector (A–1) and turn on the starter switch.
2. The car stops, the AT selector is the N position, and the brake
is applied.
3. Select the TOD switch to the 4L position.
4. After the transfer has changed to the 4L mode, disconnect the
connector (A–1).
Is there the continuity between the connector terminal (A–1) 12
and GND?
GND is
short-circuited
between
terminals (A–1)
12 and (H–7) 5.
Repair the circuit.
Go to Step 9
Repair the
transfer.
Go to Step 9
9 Check that all the parts are mounted.
Is this step complete?
Verify the repair. Go to Step 9