Workshop Manual

4B2–109
DRIVE LINE CONTROL SYSTEM (TOD)
Step Action Yes No
1 Do the indicator lamps show the correct status?
Go to Step 2
Examine the
trouble based on
“Trouble
Diagnosis
Depending on the
Status of TOD
Indicator”.
2 Is any of the trouble codes 28(P1760), 32(P1761) and 33(P1762)
recorded?
Examine the
trouble based on
“Diagnosis from
Trouble Codes”.
Go to Step 3
3 Turn on the starter switch.
Is the battery voltage observed between terminals 14 and 47?
Go to Step 4 Go to Step 5
4 When the TOD Switch is selected to the 2H position, are the front
axle gears correctly disengaged (and when the left front tire is
jacked up and turned, is the front propeller shaft standstill)?
The phenomenon
is not
reproduced.
Refer to “Trouble
intermittently
observed” .
The shift on the
fly system is
failed (refer to
Section 4B1 and
4C ).
5 Does the battery voltage maintain the correct level?
Repair the battery
circuit.
Go to Step 6
Repair the battery
and charging
system.
Go to
Step 6
6 Check that all the parts are mounted.
Is this step complete?
Verify the repair. Go to Step 6