Workshop Manual

DRIVE LINE CONTROL SYSTEM (TOD)
4B2–118
Chart 7 The transfer does not change to low from high.
Function of circuit —
Fail condition When the TOD switch is selected to the 4L position, the transfer does not change to the
low position. (The transfer stays neutral and the vehicle does not run.)
Step Action Yes No
1 1. Turn on the starter switch.
2. Set the TOD switch to the any position.
Is the transfer changed to high or low?
Go to Step 2 Go to Step 3
2 Is the transfer changed to high from low and the low from high? The phenomenon
is not
reproduced.
Refer to “Trouble
intermittently
observed”.
Go to Step 3
3 Is any of the trouble codes 41 (P1741), 42 (P1773), 43 (P1743),
and 55 (P1755) recorded?
Examine the
trouble based on
“Diagnosis from
Trouble Codes”.
The transfer is
abnormal. Repair
the transfer.
Go to Step 4
4 Check that all the parts are mounted.
Is this step complete?
Verify the repair. Go to Step 4