Workshop Manual

4C–5
DRIVE SHAFT SYSTEM
Reassembly
1.Install wheel pin.
B Place hub on a wood workbench or a block of wood
approx. 6” by 6” to protect the wheel stud ends and
threads.
B Install wheel stud, using a hammer.
NOTE: Be sure wheel stud is started squarely and seats
completely.
411RS005
2.Align scribe marks(1) and attach the hub to disc then
tighten the bolts to the specified torque.
Torque: 103 N·m (76 lb ft)
411RS003
3.Install inner bearing.
Install the outer race by driving it into the hub by using
installer J–36829 and grip J–8092.
411RS023
4.Install outer bearing.
Install the outer race by driving it into the hub by using
installer J–36828 and grip J-8092.
901RW056