Workshop Manual

4C–8
DRIVE SHAFT SYSTEM
Front Hub and Disc (4WD Model)
Disassembled View
411RW001
Legend
(1) Bolt
(2) Cap
(3) Snap Ring and Shim
(4) Hub Flange
(5) Lock Washer and Lock Screw
(6) Hub Nut
(7) Outer Bearing
(8) Bolt
(9) Hub and Disc Assembly
(10) Wheel Pin
(11) ABS Sensor Ring
(12) Inner Bearing
(13) Oil Seal
Disassembly
1.Before disassembly, select the 2WD position with the
4WD switch.
2.Jack up the front of vehicle and support frame with
jack attached.
3.Remove the two bolts from the rear side of the
knuckle arm, then remove the brake caliper, with the
brake hose attached.
Use a wire to attach the brake caliper to the upper link.
Refer to Disk Brakes in Brake section.
4.Remove Bolt.
5.Remove cap.