Workshop Manual

4C–16
DRIVE SHAFT SYSTEM
7.Remove ball retainer, ball guide and bellows.
8.Raise the hooked end of the band with a screwdriver
or equivalent.
412RS014
9.Remove band(1).
10.Remove bellows.
11.Remove dust seal.
12.Remove BJ shaft assembly.
13.Remove the mounting bracket fixing bolts, and then
remove DOJ case assembly from the axle case.
14.Remove snap ring and bearing.
15.Remove snap ring and oil seal.
16.Remove bracket.
Inspection And Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts.
1.Drive shaft joint assembly
2.DOJ case, ball, ball guide, ball retainer
3.Bellows
4.Bearing
5.Dust seal, oil seal
Bushing Replacement
B Remove the bushings using a remover J–39378–1
and hammer.
412RS015
B By using installer J–39378–2 and base J–39378–3,
press fit the bushings into the bracket.
412RS016