Workshop Manual

4C–21
DRIVE SHAFT SYSTEM
Inspection And Repair
Inspect the removed parts. If there are abnormalities
such as wear and damage, take corrective action or
replace.
Visual Check
1.Check and see if the inner shaft has such
abnormalities as wear and damage.
412RW014
2.Replace the shaft if any signs of deterioration in the
gear is present.
420RS008
Inner Shaft Run–Out
With both end centers supported, rotate the shaft slowly
and measure deflection with a dial gauge.
Limit: 0.5 mm (0.02 in)
NOTE: Do not heat the shaft to correct its bend.
412RS026
Inner Shaft Bearing
412RW006
Legend
(1) Inner Shaft Bearing
(2) Inner Shaft
(3) Clutch Gear
1.Inspect the inner shaft bearing for any signs of
deterioration, replace if uneven.
2.Insert the clutch gear and inspect the needle bearing.
3.Replace the needle bearing if found to be uneven.